Light-weight aluminum coupler will join any two 5/8" pins, either parallel or at 90°. 

A stainless steel connector for Card-a-Links. Allows unlimited variation in angles between two Card-a-Links. Ends are tapped 3/8"-16 for added versatility

Two Card-a-Links and one Swivel Connector. Attach two 5/8" pins at any angle. 

These 3/8"-16 x 1/2" set screws will allow you to mount a Card-a-Link on the camera support rods without scarring them. No picture.

A 6" x 5/8" diameter aluminum pin with a spud at each end.

Keep your Cardellini Clamps like new with pre-cut, peel and stick jaw pads. 4-pack of pads identical to the originals.

An 11" x 5/8" diameter aluminum pin with a spud at each end. Like 6BP but longer and clear anodized. No picture.